FITTINGS

A ¼” barbed connector is used to transfer water from ½” tubing to ¼” tubing by punching a hole in the ½” tubing and inserting the connector. You can also use it to connect two pieces of ¼” tubing.

A ¼” barbed tee is used to branch off of ¼” vinyl tubing into two different directions. You can also use it to branch off two pieces of ¼” polyethylene tubing from ½” tubing.

A ¼” elbow is used to create a 90 degree turn when using ¼” vinyl tubing.

A ½” compression connector (.620" x .710") is used to connect two pieces of ½” tubing in order to extend the length of tubing. You can also use it to patch a big hole in ½” tubing, by cutting out the hole and connecting the two ends of tubing with the connector.

A ½” compression tee (.620" x .710") is used to branch off ½” tubing into two different directions.

A ½” compression elbow (.620" x .710") is used to create a 90 degree turn when using ½” tubing.

A ½” compression end cap (.620" x .710") is used at the end of ½” tubing to stop the flow of water. You can also unscrew the thread cap to flush your system.

A ½” universal connector is used to connect two pieces of ½” tubing in order to extend the length of tubing. You can also use it to patch a big hole in ½” tubing, by cutting out the hole and connecting the two ends of tubing with the connector. All tubing ranging from .520" to .620" I.D. can be used with this fitting. The Power-Loc design allows for an easier and smoother installation process.

A ½” universal tee is used to branch off ½” tubing into two different directions. All tubing ranging from .520" to .620" I.D. can be used with this fitting. The Power-Loc design allows for an easier and smoother installation process.

A ½” universal elbow is used to create a 90 degree turn when using ½” tubing. All tubing ranging from .520" to .620" I.D. can be used with this fitting. The Power-Loc design allows for an easier and smoother installation process.